Afalafa technical parameters of plate heat exchanger M6-FG M6-MFM

The plate heat exchanger is composed of a group of metal corrugated plates, which are provided with an opening, and a liquid flow channel is formed by opening holes. The corrugated plate is arranged between a fixed fixing plate and a movable pressing plate, and is clamped by a clamping bolt. The board is provided with a gasket, which seals the passage between the boards and makes the liquid flow into the adjacent channel alternately. The number of plates is determined by the change of flow rate, physical properties of liquid, pressure drop and temperature. Plate corrugation causes liquid turbulence and supports the plate to withstand differential pressure. The corrugated plate and the pressing plate are fixed between the upper and the lower rods, and the two are fixed on the supporting frame. The interface is arranged on the fixing plate and the pressing plate if one or two liquid forms a plurality of channels in the device.

Model: M6

Typical capacity

Liquid flow rate: maximum 16 kg/s (250 GPM),

Depending on the medium, allowable pressure drop and temperature change.

Water is heated by steam: 300 to 800 kW

Plate type: M6, M6M, M6MD and M6MG

Frame type: FM, FG and FD

Standard material

Fixing plate: low carbon steel coated with epoxy paint

Nozzle: carbon steel

Metal lining: stainless steel, titanium

With rubber lining: nitrile rubber, EPDM

Plate: stainless steel: Alloy 316 / Alloy 304 titanium

A seal

M6: nitrile rubber, EPDM, HeatSeal F

M6M: nitrile rubber, EPDM, HeatSeal F

technical parameter

Pressure vessel standard, PED, ASME, pvcALS, mechanical design pressure (g) / temperature

FM pvcALS 1 MPa / 160 C

FG PED 1.6 MPa / 180 C *)

FG ASME 150 psig / 320 F

FG pvcALS 1.6 MPa / 180 C

FD PED, pvcALS 2.5 MPa / 160 C

FD ASME 300 psig / 320 F

*) FG framework can also be MPa/200 at 1.2 degrees C when used in the steam system, without a safety valve.

Maximum heat transfer surface: 390 M2 (4200 sq. ft)

Interface

Pipeline interface (FD type not applicable):

Straight pipe diameter 50 mm ISO G2 ", NPT 2"

Welded pipe diameter 50 mm

Thread inlet diameter 50 mm ISO G2"

Flange connection:

FM pvcALS diameter 50 DIN/GB/GOST PN10, ASME CI mm. One hundred and fifty

FG PED diameter 50 DIN mm 2501 PN16, ASME CI. One hundred and fifty

FG ASME size 2 "ASME CI. One hundred and fifty

FG pvcALS diameter 50 DIN/GB/GOST PN16, ASME CI mm. One hundred and fifty

FD PED diameter 50 DIN mm 2501 PN25, ASME CI. Thirty

FD ASME size 2 "ASME CI. Three hundred

Main dimensions:

Measurement unit mm (inch)

Model H W H

M6-FM 920 (367/32) (125/8) 140 () (51/2)

M6-FG 920 (367/32) (125/8) 140 () (51/2)

M6-FD 940 (37) (125/8) (150) (6) ()

The number of tightening bolts varies according to the pressure rating.