Plate pressing plate production process

1, the plate single side flow design: the whole plate heat exchanger with only one kind of plate, easier piping, easier installation and maintenance of equipment, reduce the number of plates and pads of the type and quantity of spare parts.

2, the design of the plate splitter: even the widest plate, but also can make the fluid evenly distributed in each corner of the plate, so that the minimum pressure loss in the flow zone. The plate heat exchange area of all involved in the high efficiency heat exchanger, all physical area plate into the heat exchange area of effective heat transfer, no dead, no flow dead, not prone to fouling, not prone to fouling caused by chlorine ion corrosion, can make full use of the pressure drop allowed for raising. Heat convection velocity, improving the heat exchange efficiency of the whole.

3, the board has H and L two corrugated angle: through the heat exchanger plate optimization combination, to maximize the heat transfer coefficient, reduce equipment cost

A stamping molding plate: 4, on the same plate on the same plate corrugation depth, so as to ensure that every point of contact between the intact plate cohesion, the plate without excessive stamping area. No hidden crack, sheet metal lines of the same height, the thin plate is 0.3mm. so that the bearing capacity of reinforced plate, to avoid thermal stress fatigue, avoid oscillation and high frequency fatigue corrosion caused by mechanical shaking, plate mechanical performance, avoids leakage caused latent crack, contact point distribution when the medium flows through the plate, turbulent, strengthen, to maximize the efficiency of heat transfer, reduce the weight of the equipment, to ensure the bearing requirement, obtain higher heat transfer coefficient.